.. _gettingStartedRemoteDoc:

.. index:: single: Example; Remote Control

==============
Remote Control
==============

**Control Over UART (RS-232)**

::
	
	constant SerialInAddresses { value: ['/LSE', '/LSC', '/LSG'] }

	switch LowShelfEnable {
		default:	off
		reset:		none
		meta:		'Low shelf bypass over serial communication.'
	}
	
	signal LowShelfCutoff {
		default:	100 
		rate:		none
		reset:		none
		meta:		'Low shelf cut-off frequency.'
	}
	
	signal LowShelfGain {
		default:	0.0 
		rate:		none
		reset:		MasterReset
		meta:		'Low shelf gain.'
	}

	SerialIn ( 
		addressList:	SerialInAddresses
		address:	'/LSE' 
	) 
	>> LowShelfEnable;
	
	SerialIn (
		addressList:	SerialInAddresses
		address:	'/LSC'
	)
	>> Clip (
		minimum:	80 
		maximum:	2000
		bypass:		off
	)
	>> Round (
		mode:		'Truncate'
		increment:	5
		bypass:		off
	)
	>> LowShelfCutoff;
	
	
	SerialIn ( 
		addressList:	SerialInAddresses
		address:	'/LSG'
	)
	>> Clip (
		minimum:	-20.0
		maximum:	20.0
		bypass:		off
	)
	>> Round (
		mode:		'Truncate'
		increment:	0.1
		bypass:		off
	)
	>> LowShelfGain;
	
	AudioIn[1:2]
	>> LowShelf (
		cutOff:	LowShelfCutoff
		gainDB:	LowShelfGain
		bypass:	LowShelfEnable
	)
	>> AudioOut[1:2];

Serial Control Messages:
	
/LSE T

/LSE/1 T

/LSC i 200

/LSC/1 i 200

/LSG f 3.2

/LSG/1 f 3.2

----
	
**Control Over Open Sound Control (OSC)**

::

	constant OscInAddresses { value: ['/LPE', '/LPC'] }
	
	switch LowPassEnable [2] {
		default:	off
		reset:		MasterReset
		meta:		'Low pass bypass over OSC communication.'
	}
	
	signal LowPassCutoff [2] {
		default:	100 
		rate:		none
		reset:		MasterReset
		meta:		'Low pass cut-off frequency.'
	}

	OscIn ( 
		addressList:	OscInAddresses
		address: 	'/LPE' 
	) 
	>> LowPassEnable;
	
	OscIn ( 
		addressList:	OscInAddresses
		address: 	'/LPC'
	)
	>> Clip (
		minimum:	80
		maximum:	2000
		bypass:		off
	)
	>> Round (
		mode:		'Truncate'
		increment:	5
		bypass:		off
	)
	>> LowPassCutoff;
	
	AudioIn[1:2]
	>> LowPass (
		cutOff:	LowPassCutoff
		reset:	off
		bypass:	LowPassEnable
	)
	>> AudioOut[1:2];
	
OSC Control Messages:

/LPE T

/LPE/1 T

/LPE/2 T

/LPC i 200

/LPC/1 i 200

/LPC/2 i 200